Cisco Cisco Prime Network 3.10 Installation Guide

This section provides step-by-step instructions for installing the Prime Network gateway, unit, and client software:

If you have a one-server setup, you need to install the gateway only. There is no need to install the unit because the 
gateway acts as both gateway and unit.

Installation of the gateway consists of two parts:

Installation of the gateway software on the designated server. This part should take between 10 and 20 minutes.

Configuring the gateway which takes up to an hour.

To install and configure the Cisco Prime Network gateway:

From one of the installation DVDs, launch the installer.bin file using the X client.

Enter the following details:

Gateway hostname or IP address.

Gateway username and password.

The install wizard launches and the Introduction window is displayed.

9770 and 
9771

TCP

Client > Gateway

Prime Network Vision, Administration, Events, Workflow 

9875

TCP

Client > Gateway

Spring JMX console port, used for Change and Configuration 
Management

1. If any of the ports (except for port 514) are unavailable, the installation fails.