Cisco Cisco Prime Optical 10.3 Developer's Guide
Cisco Prime Optical 10.3 GateWay/CORBA Programmer Reference Guide
502
The above notification shows:
• objectType is set to OT_AID
• objectTypeQualifier is set to OT_TRAFFIC_CONDITIONING_PROFILE
• objectName contains the TC profile name before the object was changed
• atributeList can contain up to two tuples:
• objectType is set to OT_AID
• objectTypeQualifier is set to OT_TRAFFIC_CONDITIONING_PROFILE
• objectName contains the TC profile name before the object was changed
• atributeList can contain up to two tuples:
– userLabel—If the object name has changed, userLabel provides the new user label.
– additionalInfo—Contains the indication "additionalInfo changed" if the object additionalInfo
– additionalInfo—Contains the indication "additionalInfo changed" if the object additionalInfo
has changed.
4.6 MPLS-TP Provisioning Interfaces
This section describes the following MPLS-TP provisioning interfaces:
•
•
•
•
•
4.6.1 MPLS-TP Tunnel Provisioning Interfaces
This section describes the following interfaces:
•
•
•
•
4.6.1.1 createAndActivateSNC
Synopsis
Description
This interface allows you to create and activate a subnetwork connection for the TP tunnel using
a single command. According to TMF standards, an SNC name is assigned by the EMS when it
creates an SNC. However, if the NMS must control the SNC name, it can provide the name using
the additionalInfo parameter sncName.
The layer rate that applies to TP tunnel circuits is LR_MPLS (165).
This interface allows you to create and activate a subnetwork connection for the TP tunnel using
a single command. According to TMF standards, an SNC name is assigned by the EMS when it
creates an SNC. However, if the NMS must control the SNC name, it can provide the name using
the additionalInfo parameter sncName.
The layer rate that applies to TP tunnel circuits is LR_MPLS (165).