Cisco Cisco Prime Optical 9.3 Technical References
15
Cisco Prime Optical 9.3.1 ML Provisioning Methodology
OL-25613-01
IEEE 802.17 RPR Base Card Configuration
Creating or Modifying a Port Channel Member
interface { FastEthernetN | GigabitEthernetM }
[N=0 to 11, and M=0,1]
no ip address
no mtu
no shutdown
channel-group channel-ID { mode [active | passive] }
lacp port-priority port-priority
[The range is from 1 to 65535]
Deleting a Port Channel Member
interface { FastEthernetN | GigabitEthernetM }
[N=0 to 11, and M=0,1]
no channel-group channel-ID
no lacp port-priority
shutdown
IEEE 802.17 RPR Base Card Configuration
The base card configuration is a set of commands you enter when creating the Layer 2 topology. Use the
Create Layer 2 Topology wizard > Layer 2 Topology Bandwidth pane (see
Create Layer 2 Topology wizard > Layer 2 Topology Bandwidth pane (see
) to define parameters
for IEEE 802.17 RPR provisioning.
Figure 4
Create Layer 2 Topology Wizard—IEEE 802.17 RPR Topology Creation
To create an RPR topology, apply the base card configuration to all ML-series cards in the RPR. The
topology is reported as L2 Not Ready until the base card configuration is applied to all cards. Select an
L2 Not Ready RPR in the L2 Topology table and choose Configuration > Enable L2 Service to enable
the L2 service provisioning.
topology is reported as L2 Not Ready until the base card configuration is applied to all cards. Select an
L2 Not Ready RPR in the L2 Topology table and choose Configuration > Enable L2 Service to enable
the L2 service provisioning.