Cisco Cisco Prime Optical 9.6 Technical References
10
Cisco Prime Optical 9.6 ML Provisioning Methodology
OL-27085-01
Base Card Configuration
Point-to-Point Base Card Configuration
For a point-to-point topology involved in at least one ML-series card, the other card can be ML, CE, OC,
or G1000. The point-to-point base card configuration must be applied only on the ML-series card(s)
involved in the topology.
or G1000. The point-to-point base card configuration must be applied only on the ML-series card(s)
involved in the topology.
Note
•
Prime Optical does not enable spanning tree. Therefore, verify that there are no Layer 2 loops
formed by bridged connections outside the ML network. Layer 2 loops in a network without
spanning tree enabled might cause network instability.
formed by bridged connections outside the ML network. Layer 2 loops in a network without
spanning tree enabled might cause network instability.
•
If a G1000 card is one endpoint in the point-to-point topology, a Network-to-Network Interface
(NNI) connection is assumed. That is, the class of service (CoS) coming into the G1000 is trusted
(not overwritten).
(NNI) connection is assumed. That is, the class of service (CoS) coming into the G1000 is trusted
(not overwritten).
cos priority-multicast Class of Service percent Multicast Group %1
[If Multicast Group 1
has been enabled]
cos priority-multicast Class of Service percent Multicast Group %2
[If Multicast Group 2
has been enabled]
class-map match-any SP_MANAGEMENT
[If SP Management (%) is greater than 0]
match cos SP Management Class of Service
[If SP Management (%) is greater than 0]
class-map match-any AVVID_VOICE_VIDEO
match cos Low Latency Queue Class of Service
class-map match-any AVVID_CONTROL
[If AVVID Control (%) is greater than 0]
match cos AVVID Control Class of Service
[If AVVID Control (%) is greater than 0]
class-map match-any CIR
[If Committed Rate (%) is greater than 0]
match cos Committed Rate Class of Service
[If Committed Rate (%) is greater than 0]
class-map match-all BEST_EFFORT
match any
Policy-map POLICY_QOS_OUT
class SP_MANAGEMENT
[If SP Management (%) is greater than 0]
bandwidth percent SP Management (%)
[If SP Management (%) is greater than 0]
class AVVID_VOICE_VIDEO
Priority 8
[Fixed values are not configurable]
class AVVID_CONTROL
bandwidth percent AVVID Control (%)
[If AVVID Control (%) is greater than 0]
class CIR
[If Committed Rate (%) is greater than 0]
bandwidth percent Committed Rate (%)
[If Committed Rate (%) is greater than 0]
class BEST_EFFORT
Bandwidth percent Default Best Effort (%)
Cos commit CoS Commit
Vlan dot1q tag native
l2protocol-tunnel cos 2
[Fixed value]
[The following commands are not issued by Prime Optical; rather, these are default ML
settings]
Interface {FastEthernetN|GigabitEthernetM}
[N=0 to 11 and M=0,1]
no ip route-cache
interface POS0
service-policy output POLICY_QOS_OUT
Crc {16|32}
[Crc 16 between ML and E-series; otherwise Crc 32]
[The following commands are not issued by Prime Optical; rather, these are default ML
settings]
No ip address
No ip route-cache