Cisco Cisco Prime Optical 9.6 Technical References
9
Cisco Prime Optical 9.6 ML Provisioning Methodology
OL-27085-01
Base Card Configuration
class-map match-all BEST_EFFORT
match any
Policy-map POLICY_QOS_OUT
class SP_MANAGEMENT
[If SP Management (%) is greater than 0]
bandwidth percent SP Management (%)
[If SP Management (%) is greater than 0]
class AVVID_VOICE_VIDEO
Priority 8
[Fixed values are not configurable]
class AVVID_CONTROL
bandwidth percent AVVID Control (%)
[If AVVID Control (%) is greater than 0]
class CIR
[If Committed Rate (%) is greater than 0]
bandwidth percent Committed Rate (%)
[If Committed Rate (%) is greater than 0]
class BEST_EFFORT
Bandwidth percent Default Best Effort (%)
Cos commit CoS Commit
Vlan dot1q tag native
L2protocol-tunnel cos 2
[Fixed value]
interface SPR1
Spr station-id Card#
[The valid range is from 1 to 254; it is not Spr node Card#]
[The following commands are not issued by Prime Optical; rather, these are default ML
settings]
no ip address
no keep alive
hold-queue 150 in
Interface {FastEthernetN|GigabitEthernetM}
[N=0 to 11 and M=0,1]
no ip route-cache
interface POS0
Spr-intf-id 1
Service-policy output POLICY_QOS_OUT
[The following commands are not issued by Prime Optical; rather, these are default ML
settings]
No ip address
No ip route-cache
Crc 32
interface POS1
Spr-intf-id 1
Service-policy output POLICY_QOS_OUT
[The following commands are not issued by Prime Optical; rather, these are default ML
settings]
No ip address
No ip route-cache
Crc 32
Note
•
Cisco IOS software supports multiple match cos commands for each class-map command, but
Prime Optical supports only one for each.
Prime Optical supports only one for each.
•
The multicast/broadcast feature applies only to RPR topologies and requires the ONS 15310 R5.0
or ONS 15454 R5.0 or later.
or ONS 15454 R5.0 or later.