Cisco Cisco Prime Network Analysis Module Software 5.1 Installation Guide
18
Cisco Branch Routers Series Network Analysis Module (NME-NAM-120S) Installation and Configuration Note, 5.1
OL-24402-01
How to Install, Upgrade, or Downgrade NME-NAM-120S
Upgrading the NAM Helper Image
This section describes how to upgrade the NAM helper image.
SUMMARY STEPS
1.
Download the NAM helper image from Cisco.com and store it on an FTP server.
From the Router Enable (exec) Mode Prompt
2.
service-module integrated-service-engine slot/0 reload
3.
service-module integrated-service-engine slot/0 session
Note
This will open a connection to the NAM console.
From the Service Module Interface
While the service module reboots, it displays the following prompt:
Enter *** to change boot configuration:
4.
Enter ***.
After you enter *** in Step 4 above, you will be at the bootloader prompt. From this prompt, you
can either boot the NAM helper located at a TFTP server or boot the pre-installed helper image in
the NAM flash.
can either boot the NAM helper located at a TFTP server or boot the pre-installed helper image in
the NAM flash.
–
To boot the NAM helper image that is located at a TFTP server, do Steps 5, 6, and 7. Skip Step 8.
–
To boot the pre-installed helper image on the NAM compact flash, skip Steps 5, 6 and 7, then
do Steps 8-11.
do Steps 8-11.
5.
configure
6.
show config
7.
boot helper
8.
boot compactflash
9.
Select 4, and follow the prompts.
10.
Select r, and confirm the reboot the NAM.
11.
Close the NAM console connection as described in
.
Step 3
Upgrade <ftp-url>, then follow the prompt.
Download and save the NAM helper image to the NAM
flash.
flash.
Step 4
exit
Example:
root@NAM.domain.name# exit
Cisco Network Analysis Module (NME-NAM-120S)
NAM.domain.com login:
Exit the NAM CLI prompt and get to the NAM login
prompt.
prompt.
Command or Action
Purpose