Cisco Cisco Prime Network Analysis Module Software 5.1 Installation Guide

This section contains the following information:

If you lose power or connection during any of the following procedures, the system usually detects 
the interruption and tries to recover. If it fails to do so, fully reinstall the system using the boothelper.

You can configure the network module by means of either the CLI or the GUI. This document 
presents CLI configuration instructions. For GUI configuration instructions, see the GUI’s online 
help.

Your first configuration task is to set up network module interfaces to the host router and to its external 
links. This configuration enables you to access the module to install and configure NME-NAM-120S.

The first few steps open the host-router CLI and access the router’s interface to the module. The 
subsequent steps configure the interface.

interface integrated-service-engine <slot>/0

ip address router-side-ip-address subnet-mask

or

ip unnumbered type number

[Optional, but if done, do not do Step 6] service-module ip address module-side-ip-address 
subnet-mask

[Optional, but if done, do not do Step 5] service-module external ip address external-ip-address 
subnet-mask

[Optional] service-module ip default-gateway gateway-ip-address