Cisco Cisco Prime Network Services Controller Adaptor for DFA Leaflet
C H A P T E R
4
Migration Configuration
This chapter contains the following sections:
•
•
•
•
•
•
•
•
Configuring the BGP Route Reflector on a Spine
You can add the Cisco Dynamic Fabric Automation (DFA)-specific Border Gateway Protocol (BGP)
configuration on the spine and identify the BGP route reflector.
configuration on the spine and identify the BGP route reflector.
Note the following requirements on spine switches:
• If you use a Cisco Nexus 6000 Series switch as a spine switch, do the following:
◦For a transit mode switch, you must enter the fabricpath mode transit command.
For the fabricpath mode transit command to take effect, the system must be reloaded.
Note
◦For a nontransit mode switch, you must specify a complete vn-segment range must be specified
using vni command. For example, vni 5001-10000.
• If you use a Cisco Nexus 7000 Series switch as a spine switch, do the following:
◦For a transit mode switch, you must enter the fabricpath mode transit command.
Cisco Dynamic Fabric Automation Migration Guide
OL-31503-01
29