Cisco Cisco 1 GHz GainStar Node Installation Guide
Chapter 2 Installation and Configuration
18
OL-31947-02
To Install the Housing in a Pedestal
Complete the following steps to install the housing in a pedestal.
1 Drill two 3/8” holes in the mounting plate or mounting bracket with 127 mm or
1 Drill two 3/8” holes in the mounting plate or mounting bracket with 127 mm or
215.9 mm distance. The thickness of the metal plate is 10 to 15 mm.
2 Lift the housing to the proper position on the wall or box.
3 Align the pedestal mounting holes on the bottom of the housing with the two
3 Align the pedestal mounting holes on the bottom of the housing with the two
holes drilled in the metal plate. Insert the bolts through the mounting plate into
the two threaded mounting holes.
the two threaded mounting holes.
4 Using a ½-inch torque wrench, tighten the pedestal clamp bolts from 6.8 Nm to
9.0 Nm.
Note: A slight tilt of the housing is normal. Cable tension will cause the housing
to hang more closely to vertical.
Note: A slight tilt of the housing is normal. Cable tension will cause the housing
to hang more closely to vertical.
5 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
6 Proceed to Installing the Accessories.