Cisco PowerKEY CableCARD Module 802 User Guide
Chapter 1 Set Up the CableCARD or M-Card Module
6
4017453 Rev B
8 Click Close on the DNCS System Configuration window. The DNCS System
Configuration window closes.
9 Go to Stopping and Restarting the siManager Process (on page 6).
Stopping and Restarting the siManager Process
The System Information Manager (siManager) generates SI tables. The SI tables
provide service information to CableCARD modules and hosts, M-Card modules
and hosts, set-top CableCARD hosts, and set-top M-Card hosts. To finish updating
your system in order to support OpenCable, you must stop and restart (bounce) the
siManager process by completing the following steps:
provide service information to CableCARD modules and hosts, M-Card modules
and hosts, set-top CableCARD hosts, and set-top M-Card hosts. To finish updating
your system in order to support OpenCable, you must stop and restart (bounce) the
siManager process by completing the following steps:
Important! This process will temporarily inhibit DHCTs from booting; however,
DHCTs that are already operational will not be impacted.
1 From the DNCS section of the DNCS Administrative Console Status window,
DHCTs that are already operational will not be impacted.
1 From the DNCS section of the DNCS Administrative Console Status window,
click Control. The DNCS Control window opens.
2 From the list of processes, select siManager.
3 Click Process and select Stop Process. A confirmation window opens.
3 Click Process and select Stop Process. A confirmation window opens.