Cisco PowerKEY CableCARD Module 802 Installation Guide
78-4017672-01 Rev E
21
Introduction
Based on your network, the PCG is controlled by either a DNCS or
ISDS. This chapter explains how to configure the PCG for your
particular network.
ISDS. This chapter explains how to configure the PCG for your
particular network.
If you are installing the PCG in a cable-based RF network, follow
the instructions in the section Configure the PCG on the DNCS (on
page 22).
If you are installing the PCG in an IP or RF/IP network, follow the
instructions in the section Configure the PCG on the ISDS (on page
4
Chapter 4
Configure the PCG on the
DNCS or ISDS
In This Chapter
Start the PCG Application ................................................................... 32