Cisco PowerKEY CableCARD Module 802 Installation Guide
Chapter 6 Monitor and Troubleshoot the PCG API
60
78-4017672-01 Rev E
Configuration File Settings and Parameters
Introduction
You can check the PCG configuration file settings and the parameters that were used
to provision the PCG.
to provision the PCG.
Checking the Configuration File Settings and Parameters
To find a list of settings and parameters used by the PCG, type configfileParams at
the PCG> prompt. The following information is displayed:
the PCG> prompt. The following information is displayed:
PCG> PCGConfigFileType = 1.0
RpcServerIPAddr = 172.40.90.1
AlarmServerIPAddr = 172.40.90.1
PcgApplicationName = pcg2.3.0.0
ForceDownLoad = yes
EisServerPort = 1100
EcmgPort = 4000
Serial-Device = /dev/ttyS0
PcgToDncsIfIpAddr = 172.50.90.21
PcgScsInterface = eth0
Configuration File Settings and Parameters
The following table describes the configuration settings and parameters.
Information
Description
PCG> PCGConfigFileType
Shows the version number of PCG Configuration
file
file
RpcServerIPAddr
Shows the IP address of the RPC server
AlarmServerIPAddr
Shows the IP address of the Alarm server
PcgApplicationName
Shows the name of the application installed on the
PCG
PCG