Cisco PowerKEY CableCARD Module 802 Installation Guide
After Upgrading a PCG
78-4017672-01 Rev E
71
After Upgrading a PCG
After you complete the PCG upgrade, use the following guidelines to determine
what's next:
what's next:
Refer to step 3 of the Determine bootp Setting (on page 66) procedure to recall
your configuration setup.
If you checked Yes, skip to Reboot the PCG (on page 71) to proceed.
If you checked No, you need to perform the procedures in the section
Manually Configure the PCG (on page 95).
Manually Configure the PCG (on page 95).
Reboot the PCG
Type shutdown -y -g0 -i6 and press Enter to reboot the PCG. The settings will take
effect and the PCG software will start automatically.
effect and the PCG software will start automatically.
PCG Post Upgrade Verification
1 Log onto the PCG.
2 Type cd /opt/pcg/console_app and press Enter.
3 Type ./cons and press Enter to invoke the console application. The PCG console
2 Type cd /opt/pcg/console_app and press Enter.
3 Type ./cons and press Enter to invoke the console application. The PCG console
command prompt is returned.
4 At the PCG> prompt, type vers and press Enter to verify that the correct PCG
Application version is running.
Example:
Example:
PCG> vers
PCG version: 2.3.0.1. Build date : 16 February 2010
5 At the PCG> prompt, type edgeinfo 0 1 and press Enter to verify sessions have
been built on the PCG.
PCG> edgeinfo 0 1
----------Edge 0 (non provisioned)----------
Edge ip address = 0x00 Total sessions created = 103 Currently active
sessions = 198
Session ID: 0x01 0x00 0x00 0x00 0x22 0x6E 0x00 0x00 0x0C 0x24
Program Number = 0 Transport Stream ID = 0 Session state = ACTIVE
Session ID: 0x00 0x00 0x00 0x00 0x2F 0x48 0x00 0x00 0x1E 0x61