Cisco Multimedia Stretch Tap Technician Access Installation Guide
Installing the Stretch Tap in a Pedestal
590212 Rev G
21
5 Using a #2 blunt-nose Phillips-head screwdriver, replace the screw securing the
seizure block to the tap housing as shown in the diagram below. Tighten the
screw to 10 in-lb (1.13 N-m).
screw to 10 in-lb (1.13 N-m).
6 Proceed to To Install the Stretch Tap in a Pedestal (on page 21).
To Install the Stretch Tap in a Pedestal
Complete the following steps to install the stretch tap in a pedestal.
1 Remove the pass-through cable. Refer to To Remove the Pass-Through Cable (on
1 Remove the pass-through cable. Refer to To Remove the Pass-Through Cable (on
page 19).
2 Remove the faceplate. Refer to Removing the Faceplate (on page 13).
3 Using a 3/8-in. wrench, remove the strand clamp bolt from the housing.
4 Mount the housing to the pedestal mounting bracket using the strand clamp bolt.
3 Using a 3/8-in. wrench, remove the strand clamp bolt from the housing.
4 Mount the housing to the pedestal mounting bracket using the strand clamp bolt.
Use the strand clamp as a spacer, if necessary.
5 Using a 3/8-in. wrench, tighten the strand clamp bolt from 30 in-lb to 40 in-lb
(3.4 N-m to 4.5 N-m).