Cisco Dual Tier Addressable Stretch Tap Installation Guide
Installation Procedure
590212 Rev G
37
3 Cut back the web a distance of 16 to 18 in. (40.6 to 45.7 cm) or whatever length is
appropriate for your installation. Add the F-connectors to the ends of the coax
cable per manufacturer specifications. The coax cable should gently bend to
connect the F-ports. The twisted pair should enter at the bottom of the Twisted
Pair module.
cable per manufacturer specifications. The coax cable should gently bend to
connect the F-ports. The twisted pair should enter at the bottom of the Twisted
Pair module.
4 Cut off approximately 2 in. (5.1 cm) of the outer sheath so that the two twisted
pair wires are exposed.
5 Proceed to To Attach the Module to the Tap (on page 37).
To Attach the Module to the Tap
After preparing the twisted pair coax cable, complete the following these steps to
attach the Twisted Pair module to the tap.
1 Inspect the back of the module carefully and confirm that the electrical
attach the Twisted Pair module to the tap.
1 Inspect the back of the module carefully and confirm that the electrical
connections are straight. If necessary, carefully straighten out any bent electrical
connections. Check to be sure that the electrical connection guides move up and
down freely.
connections. Check to be sure that the electrical connection guides move up and
down freely.