Cisco Cisco Surge-Gap Passives Installation Guide
78-589863-01 Rev C
Alpha Amp Clamp for Power Inserter Installation Instructions
3
Installing the Alpha Amp Clamp
Installing the amp clamp
Follow the steps in the table below to install the amp clamp in the power inserter.
Step
Action
1
Using a 3/8-in. nut driver, loosen the four captive bolts on the faceplate.
2
Grasp two bolts on the faceplate and pull straight out from the power
inserter housing.
3
Locate the Port 4 label on the exterior of the power inserter housing.