Cisco Cisco Surge-Gap Passives Installation Guide
4
Alpha Amp Clamp for Power Inserter Installation Instructions
78-589863-01 Rev C
Installing the Alpha Amp Clamp,
Continued
Installing the amp clamp
(continued)
Step
Action
4
Place the amp clamp board, SCR side down, in the Port 4 corner of the
power inserter housing. Align the two holes in the board with the two
mounting holes in the housing.
5
Insert the two mounting screws into the amp clamp board and tighten
from 10 in-lb to 12 in-lb (1.13 Nm to 1.35 Nm) to ensure a good ground
connection.
6
Remove the power inserter fuse from the faceplate (closest to the vertical
L-shaped metal RF shield) and insert it into the amp clamp’s fuse holder.