Cisco Cisco Content Delivery Engine 220 Technical References
MegaRAID SAS Controller Replacement Procedure
OL-27138-01
All contents are Copyright © 2012 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
13
MegaRAID controller. This can be done when initializing the new MegaRAID controller during
the first booting up after replacing the controller if prompted.
the first booting up after replacing the controller if prompted.
1. Power up the server. During the first time after replacing the MegaRAID controller, if the
following messages
” Memory/battery problems were detected” “The adapter has
recovered, but cached data was lost” are seen as in the below figure, then press any key
to continue. Other messages could be displayed on the local RGB monitor shown in
Figure 11. The console will then pause waiting for operator input:
to continue. Other messages could be displayed on the local RGB monitor shown in
Figure 11. The console will then pause waiting for operator input:
Figure 11: Messages displayed on the screen
Note: If the prompt to import the “Foreign configuration” was not seen as above, go to
#10.
#10.