Cisco Cisco Content Delivery Engine 220 Technical References
MegaRAID SAS Controller Replacement Procedure
OL-27138-01
All contents are Copyright © 2012 Cisco Systems, Inc. All rights reserved. Important Notices and Privacy Statement.
57
Appendix D
Procedure to clear the existing configuration on a 9261-8i MegaRAID
controller card without risking the configuration on internal disk drives
controller card without risking the configuration on internal disk drives
1. Shutdown and power off the system
2. Open the system and remove the SAS cable from the MegaRAID card
3. Boot the server, use Ctrl-H command to enter WebBIOS configuration when
2. Open the system and remove the SAS cable from the MegaRAID card
3. Boot the server, use Ctrl-H command to enter WebBIOS configuration when
prompted at The MegaRAID BIOS prompt
Figure D1- MegaRaid prompt during bootup
4.
Select “Start”
Figure D2: Getting into MegaRAID WebBIOS Configuration Utility
5.
Select “Configuration Wizard”