Cisco Headend System Release 2.5
738185 Rev B
Disabling OSM Automux
4-9
Restart the OSM Process
Introduction
After you have stopped the OSM process, exited and re-entered the CDE, your next
step is to restart the OSM process.
Restarting the OSM Process
Complete these steps to restart the OSM process.
1.
On the DNCS tab of the DNCS Administrative Console, click the Utilities tab.
2.
Click xterm. An xterm window opens.
3.
Type dncsControl and press Enter. A Dncs Control window opens and
displays the Main Menu.
4.
Type the number corresponding to Startup / Shutdown Single Element
Group and press Enter.
5.
Type the number corresponding to the OSM process group and press Enter.
6.
Type e and press Enter.
7.
Type the number corresponding to the OSM process and press Enter. The
following information appears:
Enter target status for element, in the range 1-3.
Possible values are:
[ 1 ] stopped(1)
[ 1 ] stopped(1)
[ 2 ] running(2)
[ 3 ] paused(3)
Default value: running(2)
Default value: running(2)
cpElmtExecTargetState--------?>
8.
Type the number corresponding to running and press Enter.
9.
Type y and press Enter to confirm.
10. Wait about 10 seconds and press Enter. The OSM process starts running.