Cisco Cisco Digital Service Access Node (DSAN) 8210 Installation Guide
Chapter 3 Hardware Installation
60
78-4041038-01 Rev B
Installing and Removing the Power Supply Module
The power supply module attaches to the housing base with two mounting screws.
To Install the Power Supply Module
Complete the following steps to install the power supply module.
1 Open the node housing. Refer to To Open the Housing (on page 42).
2 Hold the power supply module above the right well of the housing with its label
1 Open the node housing. Refer to To Open the Housing (on page 42).
2 Hold the power supply module above the right well of the housing with its label
oriented as shown below.
3 Insert the module into the housing, and align its mounting screws with the holes
at the base of the well.
4 Secure the module by tightening the two module retaining screws. Tighten
slotted head screws to 6 to 9 in-lb (0.7 to 1.0 Nm), or cross head screws to 18 to 20
in-lb (2.0 to 2.25 Nm).
in-lb (2.0 to 2.25 Nm).
5
Attach the power cable connector plug to the connector labeled POWER 1.
6 Close the housing. Refer to To Close the Housing (on page 42).