Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
6 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
7 Proceed to
Installing Accessories (on page 29).
To Install the Node in a Pedestal
Complete the following steps to install the node in a pedestal.
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
1 Remove the cover of the pedestal.
2 Remove the self-tapping bolts from the strand clamps and set the bolts and
strand clamps aside.
3 Position the housing in the pedestal frame as shown in the following illustration.
Line up the self-tapping bolt holes on the bottom of the housing with the
mounting holes on the bracket.
Note: The housing mounts to the bracket provided by the pedestal manufacturer.
4 Secure the housing to the bracket by using the bolts that you removed in step 2.
Use the strand clamps as spacers if necessary. Torque the bolts from 8 ft-lb to 10
ft-lb (10.8 Nm to 13.6 Nm).
5 Connect the coaxial cable to the pin connector according to connector
manufacturer specifications.
6 Proceed to
Installing Accessories (on page 29).
28
OL-29644-03