Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
3 Install other options or accessories as desired, or proceed to
Installing the
Amplifier Module (on page 33).
To Install Equalizers
Note: For best results, follow this installation procedure exactly.
Complete the following steps to install the equalizers in the amplifier.
1 Begin this procedure with the housing open. Refer to
Complete the following steps to install the equalizers in the amplifier.
1 Begin this procedure with the housing open. Refer to
To Open the Node Housing
(on page 15).
Note: These accessories can be installed without removing the amplifier cover.
Note: These accessories can be installed without removing the amplifier cover.
2 Install the forward interstage equalizer specified by the design print in the
forward interstage equalizer slot. Or, install the correct inverse equalizer
specified by the design print for your system in the forward interstage equalizer
slot. For a list of available GainMaker Node accessory pad values and part
numbers, refer to Technical Information (on page 79).
Note:
Note:
Be sure all the pins on the forward input equalizer or inverse equalizer
bottom align with the pin holes in the equalizer slot, allowing the equalizer to
install flat against the amplifier module.
The same inverse equalizer is used for either 870 MHz or 1 GHz.
The plug-in interstage equalizer produces the total internal tilt for the station.
To optimize performance, the plug-in interstage equalizer value is different
for each amplifier type.
3 Install other options or accessories as desired, or proceed to
Installing the
Amplifier Module (on page 33).
30
OL-29644-03