Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
Chapter 2 Installation and Configuration
To Remove the Status Monitor Transponder Module
Follow the same approach to remove the HMS Transponder and the DOCSIS
Transponder. Complete the following steps to remove the status monitor module.
1 Open the node housing. Refer to
1 Open the node housing. Refer to
To Open the Node Housing (on page 15).
2 Using a screwdriver, loosen the two module retaining screws on the
transponder.
3 With a firm grip, pull up on the transponder and remove from the interface
board.
4 Close the node housing. Refer to
To Close the Node Housing (on page 15).
5 For complete instruction on removing the DOCSIS Transponder, refer to the
Cisco DOCSIS®/EuroDOCSIS™ Transponder for GainMaker Node Installation
and Operation Guide, part number 4042915.
44
OL-29644-03