Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
GainMaker Node Seg2Way
Transponder Installation Instructions
Transponder Installation Instructions
Overview
Audience
These installation instructions are intended for all cable system operators or
installers who need to install and configure a Seg2Way
™
Transponder in a
GainMaker
®
Node.
Introduction
The Seg2Way Transponder, part number 4026194.xx, is designed to be installed in
the GainMaker Node housing lid. The transponder must be configured before it
is added to your network and activated by CheetahNet
™
. These installation
instructions describe how to install and configure the transponder.
Note: Refer to the CheetahNet Administration Guide (Tollgrade part number
Note: Refer to the CheetahNet Administration Guide (Tollgrade part number
6510-30-0357) provided with your CheetahNet software for information on adding
the transponder device to your network after it is configured.
The Seg2Way Transponder can be configured in either of the following
The Seg2Way Transponder can be configured in either of the following
conditions:
On site after it is installed in a powered node
In a powered node on a test bench
Qualified Personnel
Only appropriately qualified and skilled service personnel should attempt to
install, operate, maintain, and service this product.
WARNING:
Allow only qualified and skilled personnel to install, operate, maintain, and
Allow only qualified and skilled personnel to install, operate, maintain, and
service this product. Otherwise, personal injury or equipment damage may
occur.