Cisco GainMaker Optoelectronic Node 1GHz with 65 86 MHz Split Installation Guide
4027192 Rev B
3
Transponder Installation Procedure
GainMaker Node Transponder
Heart beat
Receive
Error
Receive
Error
Local
Control Port
Light
Sensor
GMN CMX Transponder
TX xx.x MHz RX xx.x MHz CW x MHz
TG P/N XXX-XXXX-XXX
P/N 4026194.XX COXC ID XXX
TX xx.x MHz RX xx.x MHz CW x MHz
TG P/N XXX-XXXX-XXX
P/N 4026194.XX COXC ID XXX
Programming interface
Use for setup and
transponder
programming
Use for setup and
transponder
programming
Optical Sensor
Housing Open/Closed
Housing Open/Closed
Transponder Status
Green:
Green:
Heart beat
Green:
Receive data
Red:
Error
Module Retainer
Screws
Screws
Label
Device Name
TX/RX/CW Frequencies
Part Numbers
COXC ID
Device Name
TX/RX/CW Frequencies
Part Numbers
COXC ID
Connectors
Placed inside housing
Placed inside housing
PCB Tabs
Used to ailgn connectors
Used to ailgn connectors
2 Open the GainMaker Node housing. Note the position and orientation of the
transponder in the lid of the housing.
WARNING:
Protect yourself from electric shock and our system from damage! Take
Protect yourself from electric shock and our system from damage! Take
precautions when working with this equipment. Certain components can
deliver electrical shock or cause burns.
3 Position the transponder module with the product label facing you. Align the
connectors on the other side of the transponder module with the mating
connectors on the interface board. Use the two tabs on the other side of the
transponder as a guide to position the transponder module correctly.
4 Push down on the transponder module until it clicks into place and then tighten
the two module retaining screws on the transponder to 6.2 in-lb (0.7 Nm).
5 Continue to
Transponder Configuration Procedure (on page 5) to configure the
transponder's communication features.