Cisco Model D-PCG1000 PowerKEY CAS Gateway
Configure DVS Support
4038960 Rev A
33
Configure DVS Support
After you enable DVS support on the system, you must configure the set-tops.
Configuring DVS Support During Staging
Set-tops (unless specifically configured) are configured for DVS support during
staging.
Note: The staging value for DVS support (enabled or disabled) is used by the set-top
Note: The staging value for DVS support (enabled or disabled) is used by the set-top
when it first connects to the network or when
nvm clear
is performed on the set-top.
Follow these steps to configure DVS support on set-tops during the staging process.
1 On the DNCS Administrative Console, select the Server Applications tab.
2 Click DHCT Config. The DHCT Configure window opens.
3 Click Staging Defaults.
4 In the Set Up Staging Defaults window select the Base Application tab.
5 Select the Audio: Described checkbox from the Options area:
1 On the DNCS Administrative Console, select the Server Applications tab.
2 Click DHCT Config. The DHCT Configure window opens.
3 Click Staging Defaults.
4 In the Set Up Staging Defaults window select the Base Application tab.
5 Select the Audio: Described checkbox from the Options area: