Cisco Model D-PCG1000 PowerKEY CAS Gateway
Chapter 6 Setting Up the Interactive Program Guide
74
4038960 Rev A
Add IPG Data Manually
Usually, your site receives program information from an IPG data provider and
passes that data to the IPG without altering the information at all. However, in some
cases, no data is provided. This is typically the case for local access channels. To
provide subscribers with IPG data in these instances, add the IPG data manually by
following the directions explained in this section.
Overview of Adding IPG Data Manually
To provide subscribers with IPG data when no data has been provided by the IPG
data provider, perform the following steps to manually add IPG data to the service.
1 Create an IPG service for the missing data.
1 Create an IPG service for the missing data.
Note: For assistance, see
Creating an IPG Service from an Existing SAM Service
(on page 74).
2 Map the service to an appropriate SAM service.
Note: For assistance, see
Creating an IPG Service from an Existing SAM Service
(on page 74).
3 Add IPG data for the service you created.
Note: For assistance, see
Manually Adding Data to an IPG Service (on page 75).
Creating an IPG Service from an Existing SAM Service
Complete these steps to create an IPG service so that you can manually add data to
the service.
1 From the DNCS Administrative Console, click the Server Applications tab.
2 Click IPG. The IPG Server List window opens.
3 Click IPG Services. The IPG Services List window opens.
1 From the DNCS Administrative Console, click the Server Applications tab.
2 Click IPG. The IPG Server List window opens.
3 Click IPG Services. The IPG Services List window opens.