Cisco Headend System Release 2.5 User Guide
2-2
Setting Up the TSBroadcaster
4011043 Rev B
Configure the DNCS for the TSBroadcaster
Introduction
To make the TSBroadcaster work in the Digital Broadband Delivery System (DBDS),
you must configure the DNCS for the TSBroadcaster. This section provides the
necessary steps for configuring the DNCS to work with the TSBroadcaster.
In this section, you will complete the following tasks:
•
In this section, you will complete the following tasks:
•
Configure an MPEG Source for the TSBroadcaster
•
Configure a QAM for the TSBroadcaster
•
Create a Session for the TSBroadcaster
Before You Begin
To properly configure the DNCS to work with the TSBroadcaster, the following
information must correlate on both systems:
•
•
The DNCS source ID must match the TSBroadcaster OCAP source ID.
•
The MPEG Program number on the DNCS must match the Service ID on the
TSBroadcaster.
Work closely with your system integrators to make sure that you assign the correct
information to both systems. Use the following table to record the information.
DNCS Information
TSBroadcaster Information
DNCS Source ID _____________
OCAP Source ID _____________
MPEG Program Number _____________
Service ID _____________