Cisco Headend System Release 2.5 User Guide
4011043 Rev B
Setting Up the TSBroadcaster
2-9
Configure the DNCS for the TSBroadcaster, Continued
9.
Click File > Source Definitions.
Result:
The Source Definition window opens.
10. Click File > New Digital.
Result: The Digital Source Set Up window opens.
11. Click in the first Session ID field and type 12 zeros.
Note: The system inputs the colons for you.
12. Click in the second Session ID field and type the Service Source ID you used
when you added the source in step 6.
13. Click Next.
Result: The Define Session window opens.
14. Because this source will be providing broadcast (audio/video) programming
rather than system information, click the Broadcast programming option.
15. Click Next.
Result: The Session Setup window opens.
16. Click the Input Device arrow and select the type of device (the MPEG source)
that will be providing the service content (for example, an MDR or IRT).
Example: satsb
Example: satsb
17. In the MPEG Program Number field and type the program number being fed
into the transport stream.
Important: The service ID on the TSBroadcaster and the MPEG Program
Important: The service ID on the TSBroadcaster and the MPEG Program
Number must match the program number supplied by the content provider.
For the carousel, this number must match only the service ID in the
TSBroadcaster.
18. In the Bandwidth field and type 2.
19. Click Next.
19. Click Next.
Result: The Output Selection Policy window opens.