Cisco Headend System Release 2.5 User Guide
Verify the Number of Sessions After Adding an Inband Source
4011048 Rev B
31
Verify the Number of Sessions After Adding an
Inband Source
Inband Source
Overview
This section describes how you can ensure that the new inband source was
successfully added to your system.
successfully added to your system.
Verifying the Number of Sessions on the QAM
Important! If your system is running in an RCS environment, you will need to locate
the respective QAM that is carrying the new session.
1 Facing the front of the QAM modulator, press the OPTIONS button to cycle
the respective QAM that is carrying the new session.
1 Facing the front of the QAM modulator, press the OPTIONS button to cycle
through the QAM menu screens until you see the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
Example: The following diagram shows an example of the Session Count screen.
2 Record the number of sessions in the space provided.
Total Session Count: _______
3 Did the session count increase appropriately from the value you recorded in
Verifying the Number of Sessions on the QAM (on page 12)?
If yes, go to Verify the BFS Carousel Sessions and Bandwidth Usage (on page
33).
33).
If no, from the DNCS Administrative Console, click the System Provisioning
tab and then click Source.
tab and then click Source.
4 Select the source you created, click File and select Source Definitions.