Cisco Headend System Release 2.5 Installation Guide
1-8
Initial Installation of RNCS Software
78-4003191-01 Rev B
Connect to the Console of the V240 Server
Connecting to the Console of the V240 Server
After configuring the ALOM port of the V240 server, you are ready to connect to the
console. Follow these instructions to connect to the console of the V240 server.
1. Follow these instructions to remotely log on to the ALOM port of the RNCS
server.
a) Type telnet [IP address of ALOM port] and then press Enter.
a) Type telnet [IP address of ALOM port] and then press Enter.
Note: Substitute the IP address of the ALOM port for [IP address of
ALOM port].
Example: telnet 10.201.0.2
Result: A prompt for the user ID appears.
Example: telnet 10.201.0.2
Result: A prompt for the user ID appears.
b) Type the admin user ID and then press Enter.
Result: A prompt for the password appears.
c) Type the password for the admin user and then press Enter.
Result: The SC > prompt appears as the system establishes a telnet
session between the DNCS and the ALOM port.
2. Type console -f and then press Enter.
Results:
•
•
A message appears that instructs the user on how to return to the ALOM
port.
•
Control of the V240 is returned to the console, rather than the ALOM
port.
3. Go to Install the RNCS Software, next in this chapter.