Cisco Headend System Release 2.7
Chapter 2 DNCS Configuration for Distributed BFS
14
4017541 Rev B
Establishing Connectivity Parameters for the MPEG Source
The second step in adding a device to your DNCS is to establish the connectivity
from the MPEG source to the BFS QAMs.
1 Click the Connectivity tab in the Setup MPEG Source window. The Connectivity
from the MPEG source to the BFS QAMs.
1 Click the Connectivity tab in the Setup MPEG Source window. The Connectivity
tab appears in the forefront with an illustration of any devices already connected
to this MPEG source. If no devices are connected, the illustration area is empty.
to this MPEG source. If no devices are connected, the illustration area is empty.
2 Click Create Port. The Port Number Prompt window opens.
3 In the Port Number box, type 1. This number identifies the output port on this
MPEG source.