Cisco Headend System Release 2.7
Remove the Inband Carousel From the PAT Table
78-745238-01 Rev D
161
12 Record the Session MAC Address and Session Numbers for all sessions listed
underneath the Services Portal session. Use a separate piece of paper if
necessary.
Important: List the sessions in the order they appear in the list. Later in this
Important: List the sessions in the order they appear in the list. Later in this
procedure, you will add these sessions back to the BIG PAT table in the same
order.
a Session MAC Address: ____________________________
a Session MAC Address: ____________________________
Session Number: ____________________________
b Session MAC Address: ____________________________
Session Number: ____________________________
c Session MAC Address: ____________________________
Session Number: ____________________________
d Session MAC Address: ____________________________
Session Number: ____________________________
13 Select the Services Portal session and click Delete Entry. A message appears,
asking if you want to delete the item.
14 Click Yes.
15 Click New Entry. The BIG PAT Setup window opens.
15 Click New Entry. The BIG PAT Setup window opens.
16 Enter the Session MAC Address and Session Number for the first session you
recorded in step 12.
17 Click Save.
18 Click OK.
19 Repeat steps 16 through 18 for each entry you recorded in step 12. Make sure
18 Click OK.
19 Repeat steps 16 through 18 for each entry you recorded in step 12. Make sure
you add these entries in the order in which you recorded them.
20 Close the BIG PAT window.
21 Close the Inband Data PAT window.
22 In the Set Up BFS Host window, click Save and then click Cancel.
23 Go to Tearing Down the BFS Sessions, next in this section.
21 Close the Inband Data PAT window.
22 In the Set Up BFS Host window, click Save and then click Cancel.
23 Go to Tearing Down the BFS Sessions, next in this section.