Cisco Headend System Release 2.5
Chapter 2 Install the Services Portal
36
78-745238-01 Rev D
Install the Services Portal Client
This section contains instructions for installing the Services Portal client onto the
Application Server.
The filenames and UNIX syntax in these procedures are case-sensitive. Type
The filenames and UNIX syntax in these procedures are case-sensitive. Type
filenames and paths exactly as they appear in the procedures.
Installing the Services Portal Client
1 Insert the Services Portal Client CD into the CD-ROM drive of the Application
Server. Wait for the Application Server to mount the CD.
2 In an xterm window on the Application Server where you are logged in as root
user, type df and press Enter to confirm that the Application Server mounted the
CD successfully. The last line of the df command output lists the number of free
disk blocks on the CD.
Note: The fact that the CD is listed in the df command output indicates that the
Note: The fact that the CD is listed in the df command output indicates that the
Application Server mounted the CD successfully.
3 Type cd /cdrom/cdrom0 and press Enter.
4 Type install_pkg and press Enter.
4 Type install_pkg and press Enter.
Results:
The Application Server lists the packages that will be installed.
A confirmation message appears asking you to confirm that you want to
proceed with the installation.
5 Type y and press Enter. A license agreement window appears.
6 Press Enter to start the installation. The system displays an installation
6 Press Enter to start the installation. The system displays an installation
configuration menu.
7 Verify the inband source ID (the number corresponding to INBFSSRC). Is the
inband source ID correct?
If yes, click Next.
If no, type the inband source ID for Services Portal and Press Enter.
8 Verify the out-of-band source ID (the number corresponding to OBFSSRC). Is
the out-of-band source ID correct?
If yes, Type c and press Enter to continue the installation.
If no, type the out-of-band source ID for Services Portal and type c and press
Enter to continue the installation.
The software begins loading and the system displays an installation of SAIisp
was successful message when it has completed.
9 In the xterm window, type cd / and then press Enter. The root directory becomes
the working directory.