Cisco Headend System Release 2.5 Release Notes
Appendix C
Direct ASI Installation and Configuration Procedures
132
4004148 Rev C
Enable the System for ASI
Introduction
To finally enable your system for Direct ASI, there are a few more steps you need to
complete. These steps are detailed in the following sections.
complete. These steps are detailed in the following sections.
Enable ASI From the DNCS GUI
Follow these instructions to configure the BFS QAM for ASI.
1 From the DNCS Administrative Console, select the Element Provisioning tab.
2 Click QAM. The QAM List opens.
3 Double-click the BFS QAM. The Set Up QAM window opens.
4 At the Ports field, select ASI.
5 Click Save.
6 Click Close. The Set Up QAM window closes.
7 Click File and then select Close on the QAM List window.
1 From the DNCS Administrative Console, select the Element Provisioning tab.
2 Click QAM. The QAM List opens.
3 Double-click the BFS QAM. The Set Up QAM window opens.
4 At the Ports field, select ASI.
5 Click Save.
6 Click Close. The Set Up QAM window closes.
7 Click File and then select Close on the QAM List window.
Reset the BFS QAM
Reset the BFS QAM, using one of the following methods:
The DNCS GUI
The front panel of the BFS QAM
The auditQam Utility