Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide

Page of 282
 
 
Removing and Replacing Modules 
OL-29643-02 
141 
 
Removing and Replacing Modules 
Overview 
This procedure describes how to remove and replace the internal modules of the 
GS7000 Node. All field-replaceable modules can be removed and replaced without 
removing power from the GS7000 Node. 
Field-replaceable modules include: 
 
Forward optical receiver modules 
 
Reverse optical transmitter modules 
 
Optical amplifier modules 
 
Optical switch modules 
 
Status monitor/local control module 
 
Forward configuration module 
 
Reverse configuration module 
 
Equalizers 
 
Node signal directors 
 
Power supply modules 
 
RF amplifier assembly 
 
 
CAUTION: 
Removing power from the GS7000 Node will interrupt customer 
service. Removing any module, except for the status monitor/local 
control module, will interrupt customer service unless that module has 
a redundant backup.
 
 
 
Module Replacement Procedure 
Follow this procedure to remove and replace an optical receiver, optical transmitter, 
optical amplifier, optical switch, status monitor/local control module, or power 
supply module. 
1  Open the housing. See Opening and Closing the Housing (on page 136). 
2  Carefully tag and remove any optical fibers from a receiver or transmitter 
module. 
 
    WARNING: 
Laser light hazard. Never look into the end of an optical fiber or 
connector. Failure to observe this warning can result in eye damage or 
blindness.