Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 2 Installation
14
4037424 Rev A
CAUTION:
If a pad with a value less than 10 dB is used and the transponder is used in
a GS7000 Node, there is a risk the output power of the transponder may be
too high for the node transmitter.
a GS7000 Node, there is a risk the output power of the transponder may be
too high for the node transmitter.
4 Position the transponder so that the interface connector shown below aligns with
the node interface connector.
5 The node interface connector is shown below. This connector is located on the
optical interface board (OIB) in the lid of the node.