Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Installing the Transponder
4037424 Rev A
15
6 Push the transponder down firmly onto the OIB until the transponder seats into
position. Use the screws provided with the transponder to secure the
transponder to the board. The screw locations are shown in the following
illustration. Tighten screws to 25-30 in-lbs (2.8-3.4 Nm).
transponder to the board. The screw locations are shown in the following
illustration. Tighten screws to 25-30 in-lbs (2.8-3.4 Nm).
7 If the downstream cable modem frequency is above 140 MHz, install one or both
Forward RF cables (supplied with the transponder) as follows: