Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide

 

4037424 Rev A 

47 

 

The Device combo box displays the different devices and network configurations the 
transponder can be configured to operate within. The device that is displayed 
without the box extended is the device the transponder is configured for. Choosing 
the appropriate device type is necessary to ensure the device is properly controlled 
and monitored. The available options are the following: 



 

Cisco GS7000 



 

Cisco GS7000 Dual IP 

To change the device: 
1  Select the appropriate device type, and then click the Apply button. A login 

dialog appears if the login process had not been performed previously during 
the current session. 

2  In the login dialog, enter the correct user name and password, and then click 

OK. 

Before the transponder can monitor the node it will need to be set up for how the 
node is configured. For the GS7000 Node, this can be accomplished by using either 
the SA-HMS-FIBERNODEGS7000-MIB or through the GS7000 Configuration Data 
page. For the GS7000 Optical Hub, this can only be accomplished through the 
GS7000 Configuration Data page. 

This section describes how to configure the transponder through the GS7000 
Configuration Data page. For information on how to configure the transponder by 
using the SA-HMS-FIBERNODEGS7000-MIB, see Configuring the Transponder 
Using the SA-HMS-FIBERNODEGS7000 MIB (on page 21).