Cisco Model GS7000 4-Port Node 1 GHz with 42 54 Split Installation Guide
Chapter 3 Configuration
30
4015678 Rev B
a Using the Auto-Setup button. See Configuring the LCM Using the Auto-
Setup Button (on page 23).
b Using remote configuration capabilities. See Using Remote Configuration
Capabilities below.
Using Remote Configuration Capabilities
A Model GS7000 Node can be configured from the headend ONLY if certain pieces
of software are loaded at the headend, as follows.
A Model GS7000 Node can be configured from the headend ONLY if certain pieces
of software are loaded at the headend, as follows.
If MG-Soft Browser is used: GS7000 Proprietary MIB (part number 7010289) is
required. This MIB has most of the configuration elements, some others (i.e.,
reverse port settings are in the HMS MIB).
required. This MIB has most of the configuration elements, some others (i.e.,
reverse port settings are in the HMS MIB).
If Transmission Network Control System (TNCS) is used: TNCS version 3.1.30
or later, that includes a GS7000 devtype file, is required (ATL_RosaEM_3.1.50).
or later, that includes a GS7000 devtype file, is required (ATL_RosaEM_3.1.50).
If Tollgrade Cheetah Net monitoring software is used: Although Cheetah 3.2 has
HMS capabilities, it requires a GS7000 proprietary driver to fully configure a
node.
HMS capabilities, it requires a GS7000 proprietary driver to fully configure a
node.