Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Add Table-Based QAM Information to the DNCS
4001444 Rev C
59
6 Click OK. The Alert window closes and the Table-Based QAMs List window
updates to show the TB-QAM modulator in the list.
7 Now that you have added the TB-QAM modulator to the DNCS, configure the
RF parameters for the TB-QAM modulator. Go to Enter RF Output Information
Into the DNCS (on page 59).
Enter RF Output Information Into the DNCS
Follow these instructions to enter the RF ouptput configuration information for this
TB-QAM modulator into the DNCS.
1 In the Table-Based QAM window, select the TB-QAM modulator that you just
1 In the Table-Based QAM window, select the TB-QAM modulator that you just
added and click Configure RF Parameters. The RF Parameters window opens
for this TB-QAM modulator.
2 Click Add. New data fields appear similar to the following example:
3 Follow these instructions to enter data in the new data fields:
TSID – Enter the TSID that has been assigned to the RF carrier to uniquely
identify the output transport stream. This number is used by DHCTs to
automatically identify their service groups.
Frequency – Enter the frequency assigned for this port (carrier).