Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Session Setup Overview
4001444 Rev C
73
Session Setup Overview
This section provides an overview of how to set up different types of sessions on a
Netcrypt Bulk Encryptor. Other sections in this chapter provide detailed instructions
for setting up these sessions.
Before You Begin
Before you begin setting up sessions on a Netcrypt Bulk Encryptor, make certain that
you have first provisioned the Netcrypt Bulk Encryptor and its associated devices,
such as TB-QAMs. For assistance, see Provisioning the Netcrypt Bulk Encryptor and
Associated Devices (on page 47).
Overview of Setting Up a Session Using a Netcrypt Bulk Encryptor
The steps you take to set up a session on a Netcrypt Bulk Encryptor differ according
to the type of session you are setting up. The following instructions provide an
overview of how to set up the following types of sessions using a Netcrypt Bulk
Encryptor:
TSR
CF session
Process for Setting up a CF Session
Follow these steps to set up a CF session using a Netcrypt Bulk Encryptor and send
it to a TB-QAM or GQAM.
1 If you have not already done so, provision the Netcrypt Bulk Encryptor and
1 If you have not already done so, provision the Netcrypt Bulk Encryptor and
associated devices on the DNCS.
Note: For assistance, see
Note: For assistance, see
Provisioning the Netcrypt Bulk Encryptor and
Associated Devices (on page 47).
2 Set up a CF session on this Netcrypt Bulk Encryptor.
Note: For assistance, go to
Set Up a CF Session on a Netcrypt Bulk Encryptor (on
page 75).
3 Filter the Session List to verify that the session was created successfully.
Note: For assistance, go to
View CF Sessions Carried on Netcrypt Bulk
Encryptors (on page 83).
Process for Setting Up a Transport Stream Route
Follow these steps to set up a TSR using a Netcrypt Bulk Encryptor.