Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 4 Setting Up CF Sessions and Transport Stream Routes on a NOBE
72
4012215 Rev B
8 Enter the following information in the OUTPUT fields on the Overlay Transport
Stream Route window:
Destination IP Address - IP address of the receiving device
UDP Port - The UDP port number of the receiving device
Output Port - The number of the physical GbE port that will be used for this
stream, as labeled on the back panel. We recommend that you select Port 2.
stream, as labeled on the back panel. We recommend that you select Port 2.
Rate Mbps - The rate (in Mbps) of the transport stream being sent from the
NOBE
Important: This value must match the Bandwidth value exactly.
NOBE
Important: This value must match the Bandwidth value exactly.
9 Click Save. The system saves your changes and opens the Overlay Transport
Stream Routes window, which now shows the TSR you just created. The status
area of the window shows the message "NOBE Transport Stream Saved
Successfully."
area of the window shows the message "NOBE Transport Stream Saved
Successfully."
10 Do you need to set up another Overlay TSR on this NOBE or on another NOBE?
If yes, repeat steps 2 to 9 to set up another Overlay TSR on this NOBE or on
another NOBE.
another NOBE.
If no, you have successfully set up all the Overlay TSRs required.
Note: You can create as many as 17 Overlay TSRs on one NOBE.
11 Set up a session for this Overlay TSR. Go to Create an Overlay Session (on page