Cisco Model D-PCG1000 PowerKEY CAS Gateway Installation Guide
Chapter 4 Setting Up CF Sessions and Transport Stream Routes on a NOBE
74
4012215 Rev B
6 Enter or select the following information for the Session Parameters fields on the
Overlay Session Definition window:
Session ID - The identifier for the Overlay session. (The first field of the
session ID includes 12 zeros separated in pairs by a colon; the second field
includes the Source ID for the session as listed in the Source List window. For
example, an Overlay session created from a source with a Source ID of 1500,
would use a Session ID of 00:00:00:00:00:00 1500.)
session ID includes 12 zeros separated in pairs by a colon; the second field
includes the Source ID for the session as listed in the Source List window. For
example, an Overlay session created from a source with a Source ID of 1500,
would use a Session ID of 00:00:00:00:00:00 1500.)
Source Name (Source ID) - The identifier that represents the source for this
session
session
Input IP Address - Varies according to the transmission method:
–
–
For unicasts, the IP Address of the GbE port on the NOBE
–
For multicasts, the IP multicast address assigned to that content
Input UDP Port - The UDP port that receives the clear input program
Bandwidth - The amount of bandwidth (in Mbps) that the system should
reserve for the service this session provides
Note: This value is usually defined by your content service provider, or it can
be set using a re-rating or re-coding device. Typical values are:
reserve for the service this session provides
Note: This value is usually defined by your content service provider, or it can
be set using a re-rating or re-coding device. Typical values are:
Standard MPEG video streams use 3.75 Mbps
HDTV streams use 12 to 15 Mbps
Audio streams use 0.2 Mbps
Destination IP Address - The IP address of the receiving device
Destination UDP Port - The UDP port of the receiving device
Source IP Address 1 - The IP multicast address of the source device, such as
a GbE multiplexer
a GbE multiplexer
In Program Number - The MPEG program number of the desired program
in the transport stream. This number must match the program number of the
MPEG source as defined by your content provider.
in the transport stream. This number must match the program number of the
MPEG source as defined by your content provider.
Out Program Number - The output program number of the Overlay session
Source IP Address 2 - The IP multicast address of the backup source. For
example, if the first multicast source fails, the DNCS would use this address
to receive the source.
example, if the first multicast source fails, the DNCS would use this address
to receive the source.
Video Percentage - Indicates that the NOBE should encrypt critical packages
of the session so that the resulting Overlay stream is made up of PowerKEY
encrypted and third-party encrypted critical packets.
We recommend 4% encryption for the video portion of the stream.
of the session so that the resulting Overlay stream is made up of PowerKEY
encrypted and third-party encrypted critical packets.
We recommend 4% encryption for the video portion of the stream.
Audio Percentage - A value of 98 in this field indicates that the NOBE should
encrypt critical packages.
Important: Always enter 98 in this field; otherwise, sessions may not be
encrypted properly.
encrypt critical packages.
Important: Always enter 98 in this field; otherwise, sessions may not be
encrypted properly.