Cisco Headend System Release 2.7 Installation Guide
Configure OIT Bridges
4017650 Rev C
65
Note: The TED interface should not be used to create the sub interfaces.
4 Select a Hub Name from the Hub Name list.
5 Type a Bridge Name into the Bridge Name field.
6 Select Unicast for the IP Flow Scheme.
7 Type the IP Address into the IP address field.
8 Type a description of this bridge into the Comment field
9 Select Mixed DOCSIS/DAVIC from the DCM drop-down list.
10 To enable OIT Bridges, select the OIT Bridge checkbox in the Set Up CMTS/OIT
5 Type a Bridge Name into the Bridge Name field.
6 Select Unicast for the IP Flow Scheme.
7 Type the IP Address into the IP address field.
8 Type a description of this bridge into the Comment field
9 Select Mixed DOCSIS/DAVIC from the DCM drop-down list.
10 To enable OIT Bridges, select the OIT Bridge checkbox in the Set Up CMTS/OIT
Bridge window. The OIT Bridge Params button is now enabled as shown in the
following example.
Important: You can only create one OIT Bridge per hub.
following example.
Important: You can only create one OIT Bridge per hub.
11 Click OIT Bridge Params in the Set Up CMTS/OIT Bridge window. A Set Up
OIT Screen window similar to the following opens.