Cisco Headend System Release 2.5 Installation Guide
Chapter 14 Messaging
172
4017650 Rev C
2 In the Target section, choose on of the following options:
To send the message to a specific MAC address or to a list of MAC addresses,
select MAC ADDRESS from the Send To drop-down list, enter the MAC
address, and then click Add to add the MAC address to the target list. Repeat
for additional MAC addresses.
select MAC ADDRESS from the Send To drop-down list, enter the MAC
address, and then click Add to add the MAC address to the target list. Repeat
for additional MAC addresses.
To send the message to a set-top group, select GROUP from the Send To
drop-down list, select the Group Name from the Group Name drop-down
list, and then click Add to add the Group name to the target list.
drop-down list, select the Group Name from the Group Name drop-down
list, and then click Add to add the Group name to the target list.
To send the message to a specific Hub, select HUB from the Send To drop-
down list, select the Hub Name from the Hub List, and then click Add to add
the Hub to the target list. Repeat for additional Hubs.
down list, select the Hub Name from the Hub List, and then click Add to add
the Hub to the target list. Repeat for additional Hubs.
To send the message to a specific Site, select SITE from the Send To drop-
down list, select a Site from the Site List, and then click Add to add the Site to
the target list. Repeat for additional Sites.
down list, select a Site from the Site List, and then click Add to add the Site to
the target list. Repeat for additional Sites.
To send the message System wide (broadcast to all DHCTs in the system),
select SYSTEM WIDE from the Send To drop-down list.
select SYSTEM WIDE from the Send To drop-down list.
3 In the Message Type section, select the configuration from the Configuration
drop down menu, and then select the audio type and content.
4 In the Message Activation section, select and/or enter the following
information: