Cisco Headend System Release 2.7 Installation Guide
Chapter 7 Provision DTACS
120
78-4036705-01 Rev D
The dataPump's session should appear active on the GQAM's output as seen
on the GQAM's LCD.
on the GQAM's LCD.
If you define a Source ID Location Type when you configure the carousel,
then the DTAs must have a VCT assigned to them, and the source must be
active on the DNCS. With these conditions met and a code image loaded on
the carousel, all VCTs will have a hidden channel for the Image Carousel
source. The hidden channel is shown on the DTA's Virtual Channel Map
Diag Screen, and the source is placed in all active VCTs.
then the DTAs must have a VCT assigned to them, and the source must be
active on the DNCS. With these conditions met and a code image loaded on
the carousel, all VCTs will have a hidden channel for the Image Carousel
source. The hidden channel is shown on the DTA's Virtual Channel Map
Diag Screen, and the source is placed in all active VCTs.
Do not manually add this source to a VCT.
Add a New Vendor and Hardware ID
Follow these steps to add a new vendor and hardware ID to the system.
1 Click Vendor and Hardware ID in the Common Download area of the DTACS
1 Click Vendor and Hardware ID in the Common Download area of the DTACS
main page. The DTA Vendor and Hardware ID Management screen appears.