Cisco Headend System Release 2.5 Installation Guide
Setting Up PassThru PID Routes
78-4036705-01 Rev D
105
Field
Description
Destination UDP
Port
Port
Enter the destination UDP port for the source (from 1 to 65535).
BSG Name
Select the BSG associated with this source from the drop-down list.
RF Port Name
Select the output RF port (QAM carrier) associated with this source
from the drop-down list.
from the drop-down list.
Unicast Source IP Addresses
1st Source IP
Address
Address
Enter the source's first unicast IP address, if applicable.
Note: If the destination IP address is multicast, then at least one
source IP address must be specified.
source IP address must be specified.
2nd Source IP
Address
Address
Enter the source's second unicast IP address, if applicable.
3rd Source IP
Address
Address
Enter the source's third unicast IP address, if applicable.
5 Click Save. The DTACS creates the user-defined source for PID routes that you
entered.
Add a PassThru PID Definition to a User-Defined Source
Follow these instructions to add a passthru PID definition to a user-defined source in
the DTACS.
1 In the Network Elements section, click PID Route Provisioning. The PID Route
the DTACS.
1 In the Network Elements section, click PID Route Provisioning. The PID Route
Provisioning window opens, listing the PID routes available to the DTACS.
2 Click View/Define Source. The User Defined Sources for PID Routes window
opens.