Cisco Headend System Release 2.5 Installation Guide

 

14 

78-4036705-01 Rev D 

Complete the following steps to configure the network management port. 
1  Type set /SP/network pendingipdiscovery=static and press Enter to disable 

DHCP for the network management port. 

2  Type set /SP/network pendingipaddress=<xxx.xxx.xxx.xxx> and press Enter to 

set the IP address of the network management port. 
Note: Replace <xxx.xxx.xxx.xxx> with the IP address for the network 
management port. 

3  Type set /SP/network/pendingipgateway=<xxx.xxx.xxx.xxx> and press Enter to 

set the Default Gateway for the network management port. 
Note: Replace <xxx.xxx.xxx.xxx> with the gateway IP address for the network 
management port. 

4  Type set /SP/network pendingipnetmask=<xxx.xxx.xxx.xxx> and press Enter to 

set the network mask for the network management port. 
Note: Replace <xxx.xxx.xxx.xxx> with the network mask for the network 
management port. 

5  Type set /SP/services/ssh state=enabled and press Enter to configure the 

network management port to use SSH. 

6  Type set /SP/network state=enabled and press Enter to enable the network 

management port. 

7  Type show /SP/network and press Enter to display the current network 

management port settings. 

8  If any of the settings are incorrect, retype the necessary command to set the 

parameter to the proper value and then repeat step 7. 

9  Type set /SP/network commitpending=true and press Enter to complete and 

implement the new network management port settings.